No factory floor, no assembly line. Four steps, one workshop, a whole lot of care. That's how a roll of filament becomes a drone that flies.
Layer by layer. The frame grows in the 3D printer — hour after hour, line after line. We print only as much material as it needs to fly. That's why it's so light.
Smooth by hand. Fresh off the printer, nothing's perfect. We deburr, sand and check every edge until the frame feels like it was cast in one piece.
Bringing it to life. Motors, battery, electronics and, on the Falke, the camera — all installed, soldered and tested by hand. Only once it hums do we move on.
Pair and go. Every drone is paired with the app and test-flown before it ships to you. Whatever lands at your door has already left the ground at least once.
